Honda Accord 2008 Manual page 2737

07/11/02 09:43:03 61TA0000_240_0014
Seat Belts
Front Seat Belt Replacement
(cont'd)
2-door Passenger's Seat Belt Lower Anchor
1. Remove the door sill trim (see page 20-97).
2. Detach the front passenger's seat belt anchor plate
and the anchor cover from the lower anchor.
3. Remove the lower anchor bolt (A), then remove the
lower anchor (B).
＊２３
4. Install the lower anchor in the reverse order of
removal, and note these items:
• Apply medium strength liquid thread lock to the
lower anchor bolt before reinstallation.
• Assemble the washers, the collars, and the
bushing on the lower anchor bolt as shown.
Lower anchor bolt installation
＊２４
TOOTHED
LOCK WASHER
SPRING WASHER
24-14 24-14
A
7/16-20 UNF
32 N·m
(3.3 kgf·m, 24 lbf·ft)
BUSHING
WAVE WASHER
COLLARS
LOWER ANCHOR
BOLT
LOWER ANCHOR
Rear Seat Belt Replacement
NOTE: Check the rear seat belts for damage (see page
24-17), and replace them if necessary.
Rear Seat Belt
1. Remove the rear seat cushion (see page 20-224).
2. Remove the lower anchor bolt (A).
B
3. Remove these items:
• 2-door:
– Rear seat-back (see page 20-222)
– C-pillar trim, both sides (see page 20-110)
– Rear shelf (see page 20-119)
– Rear side trim panel (see page 20-118)
• 4-door:
– Rear seat side bolsters, both sides (see page
20-224)
– C-pillar trim, both sides (see page 20-115)
– Rear shelf (see page 20-119)
ＴＡ０８Ａ００Ｈ４６２０００５３４０２ＫＢＡＴ００
A
7/16-20 UNF
33 N·m
(3.3 kgf·m, 24 lbf·ft)
＊０１