Honda Accord 2008 Manual page 2887

07/11/02 09:53:04 61TA0000_240_0164
SRS
DTC Troubleshooting (cont'd)
10. Install a jumper wire between the No. 1 and the
No. 2 terminals of the driver's seat wire harness or
seat position sensor harness 2P connector.
＊０２
DRAIVER'S SEAT WIRE HARNESS OR
SEAT POSITION SENSOR HARNESS 2P CONNECTOR
11. Disconnect SRS unit connector B (39P) from the
SRS unit (see step 8 on page 24-34).
12. Measure the resistance between the No. 23
terminal of SRS unit connector B (39P) and body
ground. There should be 0 1.0
＊０３
Is the resistance as specif ied?
YES
unit; replace the driver's seat position sensor
(see page 24-234). If the problem is still present,
replace the SRS unit (see page 24-223).
NO −
seat wire harness, or seat position sensor harness;
replace the faulty harness.
24-164 24-164
JUMPER WIRE
Wire side of female terminals
− .
SRS UNIT CONNECTOR B (39P)
Wire side of female terminals
− Faulty driver's seat position sensor or SRS
Open in the SRS floor wire harness, driver's
DTC 71-2x (''x'' can be 0 thru 9 or A thru F):
Short in the Driver's Seat Position Sensor
NOTE:
• Before doing this troubleshooting procedure, review
SRS Precautions and Procedures (see page 24-23)
and General Troubleshooting Information (see page
24-35).
• 2-door: Before replacing the SRS unit, check the SRS
unit software version with the HDS. If the software
version is not the latest, update the SRS unit software
(see page 24-38) and retest.
1. Clear the DTC memory (see page 24-36).
2. Turn the ignition switch to ON (II), then wait for 10
seconds.
3. Read the DTC (see page 24-36).
Is DT C 7 1-2x indicated?
YES − Go to step 4.
NO − Intermittent failure, the system is OK at this
time. Go to Troubleshooting Intermittent Failures
(see page 24-37). If another DTC is indicated,
troubleshoot the DTC.
4. Turn the ignition switch to LOCK (0), then wait for
10 seconds.
ＴＡ０８Ａ００Ｋ７９１０００Ｒ７１２ＸＦＡＡＴ００