07/11/02 09:45:58 61TA0000_240_0075
10. Disconnect SRS unit connector A (39P) from the
SRS unit (see step 8 on page 24-34).
11. Disconnect the SRS inflator simulator from the SRS
simulator lead. Do not disconnect the simulator
lead from the dashboard wire harness 4P connector.
12. Measure the resistance between the terminals of
both SRS simulator leads. There should be 1
less.
*52
DASHBOARD WIRE HARNESS
4P CONNECTOR
Is the resistance as specif ied?
YES
unit connector A (39P). Check the connection; if the
connection is OK, replace the SRS unit (see page
24-223).
−
NO
the dashboard wire harness.
070AZ-SNAA100
−
Faulty SRS unit or poor connection at SRS
Open in the dashboard wire harness; replace
or
24-75