07/11/02 09:50:46 61TA0000_240_0144
SRS
DTC Troubleshooting (cont'd)
10. Do the battery terminal reconnection procedure
(see page 22-89).
11. Turn the ignition switch to ON (II).
12. Measure the voltage between the No. 1 terminal of
SRS floor wire harness 2P connector and body
ground, and between the No. 2 terminal and body
ground. There should be less than 1.0 V.
*53
Is the voltage as specif ied?
YES
NO
−
replace the SRS floor wire harness.
13. Turn the ignition switch to LOCK (0).
14. Connect the SRS inflator simulator (jumper
connector) and the black lead (A) of simulator lead
L to the SRS floor wire harness 2P connector (B).
*04
07SAZ-TB4011A
24-144
SRS FLOOR WIRE HARNESS 2P CONNECTOR
Terminal side of female terminals
−
Go to step 13.
Short to power in the SRS floor wire harness;
B
A
070AZ-SNAA300
15. Measure the resistance between the No. 1 and the
No. 2 terminals of SRS floor wire harness 2P
connector. There should be less than 1 .
SRS FLOOR WIRE HARNESS 2P CONNECTOR
Terminal side of female terminals
Is the resistance as specif ied?
−
YES
Faulty left side impact sensor (second) or
SRS unit; replace the left side impact sensor
(second) (see page 24-228). If the problem is still
present, replace the SRS unit (see page 24-223).
NO
−
Open in the SRS floor wire harness; replace
the SRS floor wire harness.
*54