Honda Accord 2008 Manual page 2741

07/11/02 09:43:05 61TA0000_240_0018
Seat Belts
Inspection (cont'd)
Rear
＊０５
40 °
15 °
A
Rear center
＊０６
40 °
15 °
A
3. Replace the seat belt with a new assembly if there
is any abnormality. Do not disassemble any part of
the seat belt for any reason.
24-18
40 °
15 °
40 °
15 °
15 °
40 °
Inside Front
40 °
15 °
40 °
15 °
15 °
40 °
Inside
In-vehicle
1. Check that the seat belt is not twisted or caught on
anything.
2. After installing the anchors, check for free
movement on the anchor bolts. If necessary,
remove the anchor bolts and check that the
washers and other parts are not damaged or
improperly installed.
3. Check the seat belts for damage or discoloration.
Clean with a shop towel if necessary. Use only
soap and water to clean.
NOTE: Dirt build-up in the loops of the upper
anchors can cause the seat belts to retract slowly.
Wipe the inside of the loops with a clean cloth
dampened in isopropyl alcohol.
4. Check that the seat belt does not lock when pulled
out slowly. The seat belt is designed to lock only
during a sudden stop or impact.
5. Make sure that the seat belt will retract
automatically when released.
Front
6. For each passenger's seat belt, check the seat belt
retractor locking mechanism ALR (automatic
locking retractor). This function is for securing child
seats.
–1 Pull the seat belt all the way out to engage the
ALR. The seat belt should retract, but not
extend. This is normal.
–2 To disengage the ALR, release the seat belt and
allow it to fully retract, then pull the seat belt
out part-way. The seat belt should retract and
extend normally.
7. Replace the seat belt with a new assembly if there
is any abnormality. Do not disassemble any part of
the seat belt for any reason.