Honda Accord 2008 Manual page 2849

07/11/02 09:49:31 61TA0000_240_0126
SRS
DTC Troubleshooting (cont'd)
10. Measure the resistance between the No. 36
terminal of SRS unit connector A (39P) and body
ground, and between the No. 37 terminal and body
ground. There should be an open circuit or at least
1 M .
＊５２
Is the resistance as specif ied?
YES
NO −
compartment wire harness or dashboard wire
harness; replace the faulty harness.
11. Do the battery terminal reconnection procedure
(see page 22-89).
12. Turn the ignition switch to ON (II).
13. Measure the voltage between the No. 36 terminal
of SRS unit connector A (39P) and body ground,
and between the No. 37 terminal and body ground.
There should be less than 1.0 V.
＊５３
Is the voltage as specif ied?
YES
NO −
compartment wire harness or dashboard wire
harness; replace the faulty harness.
24-126
SRS UNIT CONNECTOR A (39P)
Wire side of female terminals
−
Go to step 11.
Short to ground in the left engine
SRS UNIT CONNECTOR A (39P)
Wire side of female terminals
−
Go to step 14.
Short to power in the left engine
14. Turn the ignition switch to LOCK (0).
15. Connect the SRS inflator simulator (jumper
connector) and the black lead (A) of simulator lead
L to the left engine compartment wire harness 2P
connector (B).
B
A
070AZ-SNAA300
16. Measure the resistance between the No. 36 and the
No. 37 terminals of SRS unit connector A (39P).
There should be less than 1
SRS UNIT CONNECTOR A (39P)
Wire side of female terminals
Is the resistance as specif ied?
YES − Faulty left front impact sensor or SRS unit;
replace the left front impact sensor (see page
24-233). If the problem is still present, replace the
SRS unit (see page 24-223).
NO − Open in the left engine compartment wire
harness or dashboard wire harness; replace the
faulty harness.
07SAZ-TB4011A
.
＊０４
＊５４