Honda Accord 2008 Manual page 2733

07/11/02 09:43:00 61TA0000_240_0010
Seat Belts
Front Seat Belt Replacement (cont'd)
9. Install the seat belt in the reverse order of removal,
and note these items:
• Apply medium strength liquid thread lock to the
anchor bolts before reinstallation.
• Tighten the bolts by hand first, then tighten to the
specified torque.
• Check that the retractor locking mechanism
functions (see page 24-17).
• Assemble the washer, the collars, and the
bushing on the upper anchor bolt and the
retractor bolt as shown.
• Before installing the anchor bolts, make sure
there are no twists or kinks in the seat belt.
• Make sure the seat belt tensioner connector is
plugged in properly.
• Do the battery terminal reconnection procedure
(see page 22-89).
• Check for any DTCs that may have been set
during repairs, and clear them.
Upper anchor bolt installation
＊０８
UPPER ANCHOR
BOLT
THREAD LOCK
Retractor bolt installation
＊０９
RETRACTOR
BOLT
24-10
UPPER ANCHOR COLLAR
BUSHING
TOOTHED
LOCK WASHER
COLLARS
TOOTHED
RETRACTOR
LOCK WASHER
Front Seat Belt Buckle
1. Do the battery terminal disconnection procedure
(see page 22-89), then wait at least 3 minutes
before beginning work.
2. Remove the front seat (see page 20-180).
3. Lift up the front seat, then detach the seat belt
switch connecter (A), and detach the harness clip(s)
(B) and harness holder (C) (on the 4-door
passenger's seat).
2-door driver's seat (10-way power seat)
B
4-door driver's seat (10-way power seat)
A
＊１０
A
＊１１
B