Honda Accord 2008 Manual page 2702

07/11/02 10:06:31 61TA0000_230_0258
Pairing Your Cell Phone (A One Time Procedure)
You must pair an approved Bluetooth compatible phone to the HFL before you can make and receive calls. The
following steps show you what you need to do. For a current list of approved phones and specific phone pairing
instructions for each phone, go to www.hansfreelink.com, or dial the HFL support call center at 888-528-7876. You can
also refer to the owner's manual, the phone's operating manual or the phone retailer. Make sure the vehicle is
stationary when you pair the phone:
NOTE:
• You cannot pair a phone if the vehicle is moving.
• Your phone must be in its Discovery mode.
• Up to six Bluetooth compatible phones can be paired by the HFL.
• Not all Bluetooth phones are compatible with the HFL. For a current list of approved Bluetooth phones, visit
www.hansfreelink.com, or dial the HFL support call center at 888-528-7876.
1. Turn on your phone, and follow the cell phone manufacture's prompts to activate Bluetooth.
2. Give these voice commands to the HFL system by pressing the HFL Talk button.
Phone setup
Pair
1. 2. 3. 4. (This can be any four-digit
code you want.)
Yes
3. Follow the cell phone manufacturer's instructions to put the phone in its Discovery mode. The phone will search
for the HFL. When you see HANDSFREELINK in the device list on the phone, select it.
4. When prompted, enter the four-digit PIN that you entered from step 2 into the phone. You will hear the HFL
system say ''A new phone has been found. Would you like to name this phone''?
5. Press and release the HFL Talk button, and say what the phone name will be. For example, say ''John's phone''.
You'll hear ''John's phone has been successfully paired, returning to the main menu''.
6. To pair another phone, repeat steps 1 thru 5.
Clearing the HFL system
NOTE:
• This operation clears the HFL system of all passcode(s), any paired phones, and all names in the HFL phonebook.
• Clearing the HFL system is recommend before selling the vehicle.
• If the system is locked and the pass code is lost or forgotten, see the symptom troubleshooting.
1. Press and release the HFL Talk button. After the beep, say ''System clear'' and the HFL system responds, ''This
process will clear all paired phone, clear all entries in the phonebook, clear the passcode and restore all defaults in
the system setup. Is this what you would like to do''?
2. Press and release the HFL Talk button. After the beep, say ''Yes'' and the HFL system responds, ''Preparing to
clear all paired phone, all phonebook entries, the passcode''. This may take up to 2 minutes to complete.
You say
Phone setup options are status, pair, edit, delete, and list.
The pairing process requires operation of your mobile phone. For
safety, only perform this function while the vehicle is stopped. State a
four-digit code for pairing. Note this code, it will be requested by the
phone.
1. 2. 3. 4. is this correct?
Searching for a Bluetooth phone. Make sure the phone you are trying
to pair is in Discovery mode
You'll hear this from the HFL system
！
(cont'd)
23-257