Honda Accord 2008 Manual page 2898

07/11/02 09:53:08 61TA0000_240_0175
5. Disconnect the ODS unit harness 3P connector (A)
from the front passenger's weight sensor (rear
inner side).
＊０１
6. Read the DTC.
Is DT C 16-12 indicated?
YES
NO −
inner side); replace the front passenger's seat
frame including all four front passenger's weight
sensors (see page 24-230).
7. Turn the ignition switch to LOCK (0).
8. Disconnect the ODS unit harness 18P connector (A)
from the ODS unit.
＊０２
− Go to step 7.
Faulty front passenger's weight sensor (rear
9. Measure the resistance between the No. 4 terminal
of the ODS unit harness 18P connector and body
ground. There should be an open circuit or at least
1 M .
ODS UNIT HARNESS 18P CONNECTOR
A
Is the resistance as specif ied?
−
YES Go to step 10.
NO − Short to ground in the ODS unit harness;
replace the ODS unit harness.
10. Measure the resistance between the No. 4 terminal
and No. 14 terminal of the ODS unit harness 18P
connector. There should be an open circuit or at
least 1 M .
ODS UNIT HARNESS 18P CONNECTOR
A
Is the resistance as specif ied?
YES − Faulty ODS unit; replace the ODS unit
(see page 24-232).
−
NO Short to ground in the ODS unit harness;
replace the ODS unit harness.
Wire side of female terminals
Wire side of female terminals
24-175
＊０３
＊０４
(cont'd)