Honda Accord 2008 Manual page 2703

07/11/02 10:06:31 61TA0000_230_0259
HandsFreeLink System
General Troubleshooting Information (cont'd)
3. Press and release the HFL Talk button. After the beep, say ''OK'' to proceed, or say ''Go back'' or Cancel.
4. If you said OK, after a short period of time, the HFL system will respond, ''System has been cleared. Returning to
the main menu'', the Clearing HFL system procedure is now complete.
Self-diagnostic Function
NOTE: This procedure should be used only if HDS is unavailable.
To run the self-diagnostic function, do the following:
1. Turn the ignition switch to ON (II).
2. Press and hold the HFL Back button for more than 5 seconds.
3. When the HandsFreeLink system enters the self-diagnostic function, the following will occur.
• If the system has not completed testing for DTCs, the HandsFreeLink system says The hands free system test is
in progress.
• If there is no DTC, the HandsFreeLink system says The hands free system is OK.
• If there is any DTC, the HandsFreeLink system says The hands free system needs to be serviced.
NOTE:
• The self-diagnostic function can only be initiated while the HFL is in its idle state.
• The self-diagnostic function is considered to start once the 5 seconds press and hold is detected, and ends when the
units returns to idle state.
23-258