07/11/02 09:53:03 61TA0000_240_0161
7. Read the DTC (see page 24-36).
Is DT C 62-2x indicated?
YES
NO
−
unit connector B (39P) and the SRS unit. Check the
connection between the connector and the SRS
unit. If the connection is OK, replace the SRS unit
(see page 24-223).
8. Remove the jumper wire.
9. Turn the ignition switch to LOCK (0).
10. Disconnect the SRS floor wire harness 2P
connector (A) from the front passenger's seat belt
buckle switch.
*02
11. Turn the ignition switch to ON (II).
−
Go to step 8.
Faulty SRS unit or poor connection at SRS
12. Measure the voltage between the No. 21 terminal
of SRS unit connector B (39P) and body ground.
There should be more than 10 V.
SRS UNIT CONNECTOR B (39P)
Wire side of female terminals
Is the voltage as specif ied?
−
YES
Go to step 13.
NO
−
Open in the SRS floor wire harness; replace
the SRS floor wire harness.
13. Turn the ignition switch to LOCK (0).
14. Measure the resistance between the No. 1 terminal
of the SRS floor wire harness 2P connector and
body ground. There should be 0 1.0
A
SRS FLOOR WIRE HARNESS 2P CONNECTOR
Wire side of female terminals
Is resistance as specif ied?
YES
−
Faulty front passenger's seat belt buckle
switch; replace the front passenger's seat belt
buckle assembly (see page 24-10).
−
NO
Open in the SRS floor wire harness; replace
the SRS floor wire harness.
−
.
24-161
*03
*05