Honda Accord 2008 Manual page 2829

Hide thumbs Also See for Accord 2008:
Table of Contents

Advertisement

07/11/02 09:48:18 61TA0000_240_0106
SRS
DTC Troubleshooting (cont'd)
5. Turn the ignition switch to LOCK (0).
6. Do the battery terminal disconnection procedure
(see page 22-89), then wait for 3 minutes.
7. Disconnect SRS unit connector B (39P) from the
SRS unit (see step 8 on page 24-34).
8. Check for continuity between the terminals of SRS
unit connector B (39P) according to the table. There
should be no continuity.
21-11
22-11
31-11
33-11
34-11
*51
Is there continuity?
YES
the SRS floor wire harness.
NO
(see page 24-223).
24-106
24-106
DTC
From terminal
To terminal
No. 8
No. 9
No. 8
No. 9
No. 8
No. 9
No. 8
No. 9
No. 8
No. 9
SRS UNIT CONNECTOR B (39P)
Wire side of female terminals
Short in the SRS floor wire harness; replace
Faulty SRS unit; replace the SRS unit
DTC 32-3x (''x'' can be 0 thru 9 or A thru F):
Short to Another Wire or Decreased
Resistance in the Front Passenger's Side
Airbag Inflator
Special Tools Required
• SRS inflator simulator 07SAZ-TB4011A
• SRS simulator lead L 070AZ-SNAA300
• SRS short canceller 070AZ-SAA0100
NOTE:
• Before doing this troubleshooting procedure, review
SRS Precautions and Procedures (see page 24-23)
No. 12
and General Troubleshooting Information (see page
No. 13
24-35).
No. 14
• 2-door: Before replacing the SRS unit, check the SRS
No. 15
unit software version with the HDS. If the software
No. 6
version is not the latest, update the SRS unit software
No. 7
(see page 24-38) and retest.
No. 10
No. 11
1. Clear the DTC memory (see page 24-36).
No. 24
No. 25
2. Turn the ignition switch to ON (II), and check that
the SRS indicator comes on for about 6 seconds
and then goes off.
Does the SRS indicator stay on, and is DT C 32-3x
indicated?
YES
Go to step 3.
NO
Intermittent failure, the system is OK at this
time. Go to Troubleshooting Intermittent Failures
(see page 24-37). If another DTC is indicated,
troubleshoot the DTC.
3. Turn the ignition switch to LOCK (0). Do the battery
terminal disconnection procedure (see page 22-89),
then wait for 3 minutes.
TA08A00K791000R323XFAAT00

Advertisement

Table of Contents

Troubleshooting

loading

Table of Contents