07/11/02 09:50:51 61TA0000_240_0158
SRS
DTC Troubleshooting (cont'd)
DTC 61-1x (''x'' can be 0 thru 9 or A thru F):
Open in the Driver's Seat Belt Buckle Switch
NOTE:
• Before doing this troubleshooting procedure, review
SRS Precautions and Procedures (see page 24-23)
and General Troubleshooting Information (see page
24-35).
• 2-door: Before replacing the SRS unit, check the SRS
unit software version with the HDS. If the software
version is not the latest, update the SRS unit software
(see page 24-38) and retest.
1. Clear the DTC memory (see page 24-36).
2. Turn the ignition switch to LOCK (0), then wait for
10 seconds.
3. Turn the ignition switch to ON (II), then buckle and
unbuckle the driver's seat belt several times.
4. Read the DTC (see page 24-36).
Is DT C 61-1x indicated?
YES
−
NO
time. Go to Troubleshooting Intermittent Failures
(see page 24-37). If another DTC is indicated,
troubleshoot the DTC.
5. Turn the ignition switch to LOCK (0).
6. Install a jumper wire between the No. 19 terminal
of SRS unit connector B (39P) and body ground.
*01
24-158
−
Go to step 5.
Intermittent failure, the system is OK at this
SRS UNIT CONNECTOR B (39P)
JUMPER WIRE
Wire side of female terminals
7. Read the DTC (see page 24-36).
Is DT C 61-2x indicated?
YES
−
Go to step 8.
NO
−
Faulty SRS unit or poor connection at SRS
unit connector B (39P) and the SRS unit. Check the
connection between the connector and the SRS
unit. If the connection is OK, replace the SRS unit
(see page 24-223).
8. Remove the jumper wire.
9. Turn the ignition switch to LOCK (0).
10. Disconnect the SRS floor wire harness 2P
connector (A) from the driver's seat belt buckle
switch.
A
11. Turn the ignition switch to ON (II).
TA08A00K791000R611XFAAT10
*02