Honda Accord 2008 Manual page 2835

07/11/02 09:48:20 61TA0000_240_0112
SRS
DTC Troubleshooting (cont'd)
10. Disconnect SRS unit connector B (39P) from the
SRS unit (see step 8 on page 24-34).
11. Disconnect the SRS inflator simulator from the SRS
simulator lead. Do not disconnect the simulator
lead from the SRS floor wire harness 2P connector.
12. Measure the resistance between the terminals of
the black SRS simulator lead (A). There should be
1.0
＊５２
SRS FLOOR WIRE HARNESS
2P CONNECTOR
Is the resistance as specif ied?
YES
SRS unit connector B (39P) and the SRS unit. Check
the connection; if the connection is OK, replace the
SRS unit (see page 24-223).
−
NO
the SRS floor wire harness.
24-112 24-112
or less.
070AZ-SNAA300
A
− Faulty SRS unit or poor connection at the
Open in the SRS floor wire harness; replace
DTC 33-11: Short to Another Wire in the Left
Side Curtain Airbag Inflator (4-door)
NOTE: Before doing this troubleshooting procedure,
review SRS Precautions and Procedures (see page
24-23) and General Troubleshooting Information
(see page 24-35).
1. Clear the DTC memory (see page 24-36).
2. Turn the ignition switch to ON (II), then wait for 10
seconds.
3. Read the DTC (see page 24-36).
Is DT C 33-11 indicated?
YES − Go to step 4.
NO − Intermittent failure, the system is OK at this
time. Go to Troubleshooting Intermittent Failures
(see page 24-37). If another DTC is indicated,
troubleshoot the DTC.
4. Read the DTC (see page 24-36).
Is DT C 21-11, 22-11, 31-11, 32-11, or 34-11
indicated with DT C 33-11?
YES − Go to step 5.
NO − Short in the SRS floor wire harness; replace
the SRS floor wire harness.
ＴＡ０８ＡＢ４Ｋ７９１０００Ｒ３３１１ＦＡＡＴ００