07/11/02 10:06:30 61TA0000_230_0256
General Troubleshooting Information
How to Check for DTCs with the HDS
1. Make sure the ignition switch is turned to LOCK (0).
2. Connect the HDS to the data link connector (DLC) (A) located under the driver's side of the dashboard.
*01
3. Turn the ignition switch to ON (II).
4. Make sure the HDS communicates with the vehicle and the HandsFreeLink control unit. If it doesn't, troubleshoot
the DLC circuit (see page 11-208).
5. Select HandsFreeLink in the BODY ELECTRICAL menu.
6. Select DTCs in the HandsFreeLink menu.
7. Check for DTCs. If any DTCs are indicated, write down the DTCs, then go to the indicated DTC troubleshooting. If
no DTCs are indicated, refer to symptom troubleshooting.
NOTE:
• After troubleshooting, clear the DTCs with the HDS.
• For specific operations, refer to the HDS user's manual.
TA08AN7J14233930551BBAT00
A
(cont'd)
23-255