07/11/02 09:53:05 61TA0000_240_0167
4. Turn the ignition switch to LOCK (0).
5. Check the No. 12 (7.5A) fuse in the driver's under-
dash fuse/relay box.
Is the f use OK ?
YES
−
NO
to ON (II). If the fuse blows again, check for a short
in the No. 12 (7.5 A) fuse circuit (dashboard wire
harness, SRS floor wire harness, or ODS unit
harness).
6. Disconnect the ODS unit harness 18P connector (A)
from the ODS unit.
*02
7. Turn the ignition switch to ON (II).
−
Go to step 6.
Replace the fuse, then turn the ignition switch
8. Measure the voltage between the No. 1 terminal of
the ODS unit harness 18P connector and body
ground. There should be battery voltage.
ODS UNIT HARNESS 18P CONNECTOR
Is there battery voltage?
−
YES
Go to step 9.
NO
−
Open in the SRS floor wire harness or ODS
unit harness; replace the faulty harness.
9. Turn the ignition switch to LOCK (0).
A
10. Measure the resistance between No. 12 terminal of
ODS unit harness 18P connector and body ground.
There should be 0 1.0
ODS UNIT HARNESS 18P CONNECTOR
Is the resistance as specif ied?
YES
−
Go to step 11.
−
NO
Open in the SRS floor wire harness or ODS
unit harness, or poor connection at the ODS unit
harness 18P connector and ODS unit. Check the
connection; if the connection is OK, replace the
faulty harness.
Wire side of female terminals
−
.
Wire side of female terminals
24-167
*03
*04
(cont'd)