Honda Accord 2008 Manual page 2804

07/11/02 09:47:05 61TA0000_240_0081
10. Disconnect SRS unit connector A (39P) from the
SRS unit (see step 8 on page 24-34).
11. Disconnect the SRS inflator simulator from the SRS
simulator lead. Do not disconnect the simulator
lead from the dashboard wire harness 4P connector.
12. Do the battery terminal reconnection procedure
(see page 22-89).
13. Turn the ignition switch to ON (II).
14. Measure the voltage between each terminal of the
SRS simulator lead and body ground. There should
be 0.5 V or less.
＊５２
DASHBOARD WIRE HARNESS
4P CONNECTOR
Is the voltage as specif ied?
YES
unit connector A (39P) and the SRS unit. Check the
connection between the connector and the SRS
unit. If the connection is OK, replace the SRS unit
(see page 24-223).
NO −
harness; replace the dashboard wire harness.
070AZ-SNAA100
− Faulty SRS unit or poor connection at SRS
Short to power in the dashboard wire
DTC 12-9x (''x'' can be 0 thru 9 or A thru F):
Short to Ground in the Front Passenger's
Airbag First Inflator
DTC 12-Bx (''x'' can be 0 thru 9 or A thru F):
Short to Ground in the Front Passenger's
Airbag Second Inflator
Special Tools Required
• SRS inflator simulator 07SAZ-TB4011A
• SRS simulator lead J 070AZ-SNAA100
NOTE:
• Before doing this troubleshooting procedure, review
SRS Precautions and Procedures (see page 24-23)
and General Troubleshooting Information (see page
24-35).
• 2-door: Before replacing the SRS unit, check the SRS
unit software version with the HDS. If the software
version is not the latest, update the SRS unit software
(see page 24-38) and retest.
1. Clear the DTC memory (see page 24-36).
2. Turn the ignition switch to ON (II), and check that
the SRS indicator comes on for about 6 seconds
and then goes off.
Does the SRS indicator stay on, and is DT C 12-9x
or 12-Bx indicated?
YES − Go to step 3.
−
NO Intermittent failure, the system is OK at this
time. Go to Troubleshooting Intermittent Failures
(see page 24-37). If another DTC is indicated,
troubleshoot the DTC.
3. Turn the ignition switch to LOCK (0). Do the battery
terminal disconnection procedure (see page 22-89),
then wait for 3 minutes.
ＴＡ０８Ａ００Ｋ７９１０００Ｒ１２９ＸＦＡＡＴ００
(cont'd)
24-81 24-81