Honda Accord 2008 Manual page 2889

07/11/02 09:53:05 61TA0000_240_0166
SRS
DTC Troubleshooting (cont'd)
DTC 81-4x, 81-5x (''x'' can be 0 thru 9 or A
thru F), 81-63, 81-64:
ODS Unit
NOTE: Before doing this troubleshooting procedure,
review SRS Precautions and Procedures (see page
24-23) and General Troubleshooting Information
(see page 24-35).
1. Clear the DTC memory (see page 24-36).
2. Turn the ignition switch to LOCK (0), then wait for
10 seconds.
3. Turn the ignition switch to ON (II), then wait for 10
seconds.
4. Read the DTC (see page 24-36).
Is DT C 81-64 indicated?
−
YES Go to step 5.
NO − Go to step 7.
5. Initialize the ODS unit (see page 24-39).
6. Turn the ignition switch to ON (II), and check that
the SRS indicator comes on for about 6 seconds
and then goes off.
Does the SRS indicator go of f ?
−
YES Intermittent failure, the system is OK at this
time.
NO − Replace the ODS unit (see page 24-232), then
initialize the ODS unit (see page 24-39). If the
problem is still present, replace the SRS unit
(see page 24-223).
7. Read the DTC (see page 24-36).
Is DT C 81-4x, 81-5x, or 81-63 indicated?
−
YES Replace the ODS unit (see page 24-232), then
initialize the ODS unit (see page 24-39). If the
problem is still present, replace the SRS unit
(see page 24-223).
−
NO Intermittent failure, the system is OK at this
time. Go to Troubleshooting Intermittent Failures
(see page 24-37). If another DTC is indicated,
troubleshoot the DTC.
24-166 24-166
ＴＡ０８Ａ００Ｋ７９１０００Ｒ８１４ＸＦＡＡＴ０１
Internal Failure of the
DTC 81-61: No Signal From the ODS Unit
DTC 81-62: Non Stipulated Data From the
ODS Unit
NOTE:
• Before doing this troubleshooting procedure, review
SRS Precautions and Procedures (see page 24-23)
and General Troubleshooting Information (see page
24-35).
• 2-door: Before replacing the SRS unit, check the SRS
unit software version with the HDS. If the software
version is not the latest, update the SRS unit software
(see page 24-38) and retest.
1. Clear the DTC memory (see page 24-36).
2. Read the DTC (see page 24-36).
Is DT C 81-61 or 81-62 indicated?
−
YES Go to step 3.
NO − Intermittent failure, the system is OK at this
time. Go to Troubleshooting Intermittent Failures
(see page 24-37). If another DTC is indicated,
troubleshoot the DTC.
3. Check the connection between the ODS unit
harness 18P connector (A) and the ODS unit.
Is the connection OK ?
YES − Go to step 4.
−
NO Repair the poor connection and retest. If DTC
81-61 or 81-62 is still present, go to step 4.
ＴＡ０８Ａ００Ｋ７９１０００Ｒ８１６１ＦＡＡＴ００
＊０１
A