Honda Accord 2008 Manual page 2802

07/11/02 09:46:00 61TA0000_240_0079
4. Disconnect the front passenger's airbag 4P
connector (A) from the dashboard wire harness.
＊５１
070AZ-SNAA100
5. Connect the SRS inflator simulator (2
connectors) and simulator lead J to the dashboard
wire harness.
6. Do the battery terminal reconnection procedure
(see page 22-89).
7. Clear the DTC memory.
8. Read the DTC (see page 24-36).
Is DT C 12-3x or 12-6x indicated?
YES
NO −
second inflator; replace the front passenger's
airbag (see page 24-207).
9. Turn the ignition switch to LOCK (0). Do the battery
terminal disconnection procedure (see page 22-89),
then wait for 3 minutes.
07SAZ-TB4011A
−
Go to step 9.
Short in the front passenger's airbag first or
10. Disconnect SRS unit connector A (39P) from the
SRS unit (see step 8 on page 24-34).
11. Disconnect the SRS inflator simulator from the SRS
simulator lead. Do not disconnect the simulator
lead from the dashboard wire harness 4P connector.
12. Connect a SRS short canceller (070AZ-SAA0100) to
the No. 5 and the No. 6 terminals, and the No. 9 and
A
the No. 10 terminals of SRS unit connector A (39P)
(see page 24-28).
13. Measure the resistance between the terminals of
both SRS simulator leads. There should be an open
circuit or at least 1 M .
DASHBOARD WIRE HARNESS
4P CONNECTOR
070AZ-SNAA100
Is the resistance as specif ied?
−
YES Faulty SRS unit or poor connection at SRS
unit connector A (39P) and the SRS unit. Check the
connection between the connector and the SRS
unit. If the connection is OK, replace the SRS unit
(see page 24-223).
−
NO Short in the dashboard wire harness; replace
the dashboard wire harness.
＊５２
24-79