Honda Accord 2008 Manual page 2812

07/11/02 09:47:08 61TA0000_240_0089
4. Disconnect the SRS floor wire harness 4P
connector (A) from the driver's seat belt tensioner.
＊５１
070AZ-SNAA200
5. Connect the SRS inflator simulator (2
connectors) and simulator lead K to the SRS floor
wire harness.
6. Do the battery terminal reconnection procedure
(see page 22-89).
7. Clear the DTC memory.
8. Read the DTC (see page 24-36).
Is DT C 21-9x indicated?
YES
NO −
tensioner; replace the driver's seat belt for 4-door
(see page 24-8), for 2-door (see page 24-5).
9. Turn the ignition switch to LOCK (0). Do the battery
terminal disconnection procedure (see page 22-89),
then wait for 3 minutes.
A
07SAZ-TB4011A
−
Go to step 9.
Short to ground in the driver's seat belt
10. Disconnect SRS unit connector B (39P) from the
SRS unit (see step 8 on page 24-34).
11. Disconnect the simulator lead from the SRS floor
wire harness.
12. Measure the resistance between the No. 12
terminal of SRS unit connector B (39P) and body
ground, and between the No. 13 terminal and body
ground. There should be an open circuit or at least
1 M .
SRS UNIT CONNECTOR B (39P)
Wire side of female terminals
Is the resistance as specif ied?
YES − Faulty SRS unit or poor connection at SRS
unit connector B (39P) and the SRS unit. Check the
connection; if the connection is OK, replace the
SRS unit (see page 24-223).
−
NO Short to ground in the SRS floor wire harness;
replace the SRS floor wire harness.
＊５２
24-89