Honda Accord 2008 Manual page 2823

07/11/02 09:47:11 61TA0000_240_0100
SRS
DTC Troubleshooting (cont'd)
4. Disconnect the floor wire harness 2P connector (A)
from the driver's side airbag (B).
＊５１
070AZ-SNAA300
5. Connect the SRS inflator simulator (2
connectors) and simulator lead L to the SRS floor
wire harness.
6. Do the battery terminal reconnection procedure
(see page 22-89).
7. Clear the DTC memory.
8. Read the DTC (see page 24-36).
Is DT C 31-3x indicated?
YES
NO −
airbag inflator; replace the driver's side airbag
(see page 24-209).
9. Turn the ignition switch to LOCK (0). Do the battery
terminal disconnection procedure (see page 22-89),
then wait for 3 minutes.
24-100
B
A
07SAZ-TB4011A
−
Go to step 9.
Short to another wire in the driver's side
10. Disconnect SRS unit connector B (39P) from the
SRS unit (see step 8 on page 24-34).
11. Disconnect the SRS inflator simulator from the SRS
simulator lead. Do not disconnect the simulator
lead from the SRS floor wire harness 2P connector.
12. Connect the SRS short canceller (070AZ-SAA0100)
to the No. 6 and the No. 7 terminals of SRS unit
connector B (39P) (see page 24-29).
13. Measure the resistance between the terminals of
the black SRS simulator lead (A). There should be
an open circuit or at least 1 M .
SRS FLOOR WIRE HARNESS
2P CONNECTOR
070AZ-SNAA300
A
Is the resistance as specif ied?
−
YES Faulty SRS unit or poor connection at SRS
unit connector B (39P) and the SRS unit. Check the
connection; if the connection is OK, replace the
SRS unit (see page 24-223).
NO − Short in the SRS floor wire harness; replace
the SRS floor wire harness.
＊５２