Honda Accord 2008 Manual page 2882

07/11/02 09:50:52 61TA0000_240_0159
12. Measure the voltage between the No. 19 terminal
of SRS unit connector B (39P) and body ground.
There should be more than 10 V.
＊０４
Is the voltage as specif ied?
YES
NO −
the SRS floor wire harness.
13. Turn the ignition switch to LOCK (0).
14. Measure the resistance between the No. 1 terminal
of the SRS floor wire harness 2P connector and
body ground. There should be 0 1.0
＊０５
SRS FLOOR WIRE HARNESS 2P CONNECTOR
Is resistance as specif ied?
YES
replace the driver's seat belt buckle assembly
(see page 24-10).
−
NO
the SRS floor wire harness.
SRS UNIT CONNECTOR B (39P)
Wire side of female terminals
−
Go to step 13.
Open in the SRS floor wire harness; replace
−
Wire side of female terminals
− Faulty driver's seat belt buckle switch;
Open in the SRS floor wire harness; replace
DTC 61-2x (''x'' can be 0 thru 9 or A thru F):
Short in the Driver's Seat Belt Buckle Switch
NOTE: Before doing this troubleshooting procedure,
review SRS Precautions and Procedures (see page
24-23) and General Troubleshooting Information
(see page 24-35).
1. Clear the DTC memory (see page 24-36).
2. Turn the ignition switch to LOCK (0), then wait for
10 seconds.
3. Turn the ignition switch to ON (II), then buckle and
unbuckle the driver's seat belt several times.
4. Read the DTC (see page 24-36).
Is DT C 61-2x indicated?
−
YES Go to step 5.
NO − Intermittent failure, the system is OK at this
time. Go to Troubleshooting Intermittent Failures
(see page 24-37). If another DTC is indicated,
troubleshoot the DTC.
5. Turn the ignition switch to LOCK (0).
.
ＴＡ０８Ａ００Ｋ７９１０００Ｒ６１２ＸＦＡＡＴ００
(cont'd)
24-159 24-159