Honda Accord 2008 Manual page 2888

07/11/02 09:53:04 61TA0000_240_0165
5. Manual seat: Remove the recline cover (see page
20-217).
6. Disconnect the driver's seat wire harness or seat
position sensor harness 2P connector (A) from the
driver's seat position sensor.
Power seat
＊０１
Manual seat
＊５２
7. Turn the ignition switch to LOCK (0), then wait for
10 seconds.
8. Turn the ignition switch to ON (II), then wait for 10
seconds.
9. Read the DTC (see page 24-36).
Is DT C 7 1-2x indicated?
YES − Go to step 10.
NO − Intermittent failure, the system is OK at this
time. Go to Troubleshooting Intermittent Failures
(see page 24-37). If another DTC is indicated,
troubleshoot the DTC.
A
10. Turn the ignition switch to LOCK (0).
11. Do the battery terminal disconnection procedure
(see page 22-89), then wait for 3 minutes.
12. Disconnect SRS unit connector B (39P) from the
SRS unit (see step 8 on page 24-34).
13. Measure the resistance between the No. 23
terminal of SRS unit connector B (39P) and body
ground. There should be an open circuit or at least
1 M .
A
Is the resistance as specif ied?
YES − Faulty driver's seat position sensor or SRS
unit; replace the driver's seat position sensor
(see page 24-234). If the problem is still present,
replace the SRS unit (see page 24-223).
−
NO Short in the SRS floor wire harness, driver's
seat wire harness, or seat position sensor harness;
replace the faulty harness.
SRS UNIT CONNECTOR B (39P)
Wire side of female terminals
＊０２
24-165