Rep 12.3.1 Feed/Retard/Nudger Roll (2Tm) - Xerox WorkCentre 7132 Service Documentation

REP 12.3.1 Feed/Retard/Nudger Roll (2TM)

Parts List on PL 14.4
Removal
To avoid personal injury or shock, do not perform repair or adjustment with electrical
power applied to the machine.
Check that "Ready to Copy" is displayed on the Control Panel display.
NOTE: The Feed, Retard and Nudger Roll must be replaced at the same time.
1. Remove the paper tray for the Feed, Retard and Nudger Roll to be replaced.
a. Pull out tray and remove paper.
b. Ensure tray is pulled out to the stop.
c. Lift end and pull out to remove.
2. Remove the Tray 2/3 Feeder.
• Tray 2 Feeder (REP 12.1.1)
• Tray 3 Feeder (REP 12.1.2)
3. Move the Front Chute in the direction of the arrow. (Figure 1)
1. Move the Front Chute.
Reversion 4.0
WorkCentre 7132
WARNING
CAUTION
Figure 1 Moving the Front Chute
4. Remove the Feed/Retard/Nudger Roll. (Figure 2)
1. Release the hooks (3) to remove the Feed/Retard/Nudger Roll.
January 2007
4-107
Repairs/Adjustments
REP 12.3.1