IQ15 Mottle RAP
This RAP troubleshoots the causes of output images showing image density that varies from
inboard to outboard edges, or randomly throughout the print.
Initial Actions
•
Replace the paper in use with fresh, dry paper of the correct specification. Ensure that the
loaded media matches the UI or print driver settings.
•
Determine if the Drum Cartridge or any of the Toner Cartridges are approaching end-of-
life. Replace if necessary.
•
Perform Max Setup (ADJ 9.1.2). If this does not resolve the problem, continue with this
RAP.
Procedure
Print Test Pattern 54. The defect involves a single color.
Y
N
Make a print of the Test Pattern 53. Open the Front Door when the lead edge of the print
begins to protrude from the Fuser Exit nip. Open the Fuser and examine the partially-
fused sheet. The defect is present in both the fused and unfused portion of the
sheet.
Y
N
Clean or replace the Fuser (PL 7.1).
Print Test Pattern 53. As the print is being processed, open the Front Door. Examine the
image on the Transfer Belt. The image on the belt has acceptable density.
Y
N
Replace the IBT Belt (PL 6.1). If the problem continues, replace the Drum Cartridge
(PL 4.1)
Clean/replace the 2nd BTR Assembly (PL 6.1).
If the problem continues, replace the IBT Belt (PL 6.1).
Check the following:
•
Clean the HV contact for the developer in question
•
Replace the Toner Cartridge if not done previously
•
Replace the Developer (PL 5.2). Examine the housing for damage, wear, or contamina-
tion
Image Quality
IQ15
January 2007
3-14
Reversion 4.0
WorkCentre 7132