Xerox WorkCentre 7132 Service Documentation page 1330

NVM Read/Write
Purpose
Reads, sets or changes the NVM data.
Procedure
1. Access Diagnostic Routines.
a. Enter UI Diagnostics (Entering UI Diagnostics in UI Diagnostic Mode).
b. Access Diagnostic Routines (Accessing Diagnostic Routines in UI Diagnostic
Mode).
2. Select Maintenance/Diagnostics.
3. Select NVM Read/Write.
Reading NVM
1. Input Chain-Link number(6 digits) on NVM Read/Write screen.
2. Select Confirm/Change.
3. Current Value appears in Current Value column.
Writing NVM
1. Input New number in New Value column.
2. Select Save.
3. New number appears on Current Value column.
Table 1 Component VS Chain number
Component Item IOT/IIT/Controller
ESS IF IOT
Recycle IOT
Billing IOT
Drive IOT
NOHAD IOT
PH IOT
EXIT IOT
Tray IOT
Fuser IOT
ROS IOT
Process Control IOT
Xero IOT
CRU IOT
Finisher IOT
DADF IIT
IISS (DADF) IIT
IISS IIT
IISS (Config) IIT
Common Controller
Meter Counter Controller
Stored Data Controller
Reversion 4.0
WorkCentre 7132
Component Item
I/O Port Protocol
Scan Service
IOT
IIT
UI
Copy Service
Print Service
Fax Service
iFax Service
Diagnostics
Chain Number Allocation
740
740
740
741
741
740, 742, 760
742, 764
742
744
749
751, 752, 753
751
751
764
711
710
715
719
700
720
731, 732, 733, 734
January 2007
6-7
Table 1 Component VS Chain number
IOT/IIT/Controller Chain Number Allocation
Controller 770
Controller 770, 840
Controller 780
Controller 785
Controller 790
Controller 790, 810
Controller 800, 806
Controller 820, 823, 825
Controller 830
Controller 870, 900
General procedures information
NVM Read/Write