Move the levers (2) to the up posi-
tion. It will be necessary to force
the levers by flexing them to so that
Fuser Module
the black tabs can clear the IBT
Module frame.
Figure 6 Moving the levers (2) to the retracted position
11. Place the IBT Belt Tension Handle on the shaft and rotate the Handle counter clockwise
to the down position put tension on the IBT Belt. (Figure 7)
Reversion 4.0
WorkCentre 7132
Figure 7 Re-tension the IBT Belt
12. Remove the screws (4) and the Tension Handle. (Figure 8)
January 2007
4-33
Use the handle to put tension
on the IBT Belt by rotating the
handle down.
Repairs/Adjustments
REP 4.2.2