Xerox WorkCentre 7132 Service Documentation page 1214

Figure 4 Position Adjustment of Half Rate Carriage 3/3
7. Fix the tool to the tool hole on the frame and check the tool holes of the frame and the Full
Rate Carriage. (Figure 5)
NOTE: When adjusting the position of Full Rate Carriage from the rear side, to it with the
rear tool for Half Rate Carriage installed.
1. Fix the tool.
2. Secure it with a screw.
Reversion 4.0
WorkCentre 7132
Figure 5 Position Adjustment of Full Rate Carriage 1/2
NOTE: Loosen the securing screw of the Carriage Cable and align the tool holes if the
tool holes of the frame and the Full Rate Carriage are not aligned, and the tool is not fixed
in place. (Figure 6)
1. Loosen the screw.
2. Move the Full Rate Carriage until the tool hole aligns.
3. Tighten the screw.
January 2007
4-263
Repairs/Adjustments
ADJ 11.6.1