Rep 16.8.1 Staple Unit Rail - Xerox WorkCentre 7132 Service Documentation

NOTE: When installing the Actuator, ensure the stopper is inserted into the ditch of the
Actuator as illustrated below. (Figure 6)
Figure 6 Installing the Actuator
Reversion 4.0
WorkCentre 7132

REP 16.8.1 Staple Unit Rail

Parts List on PL 17.8
Removal
To avoid personal injury or shock, do not perform repair or adjustment with electrical
power applied to the machine.
Check that "Ready to Copy" is displayed on the Control Panel display.
1. Remove the following parts:
• Staple Assembly (REP 16.8.2)
• Front Cover Assembly (REP 16.1.2)
• Rear Cover (REP 16.4.1)
2. Disconnect the connectors. (Figure 1)
1. Disconnect the connectors (x5).
2. Release the Edge Saddles (x4) to remove the wire.
3. Remove the screw to remove the Earth Wire.
January 2007
4-171
WARNING
CAUTION
Repairs/Adjustments
REP 16.7.1, REP 16.8.1