Xerox WorkCentre 7132 Service Documentation page 958

NOTE: When removing the Clutch Bracket, be careful to recover the washer from
between the Clutch Bracket and the Clutch shaft.
1
Disconnect the cable clamps from the
Clutch bracket and metal frame
Figure 9 Removing the Clutch bracket
13. Remove the screw (6) from the Main Drive Assembly. (Figure 10, Figure 11)
Reversion 4.0
WorkCentre 7132
2
Remove the screws (2) then
remove the Clutch bracket
January 2007
4-7
NOTE: Removing the (6) screws is shown in two steps in the following two figures.
1
Remove the first screws (4)
Figure 10 Removing the screws (4) first
Main Drive Assembly
2
The remaining
screws (2) are
located here
Repairs/Adjustments
REP 1.1.1