ADJ 11.6.1 Full/Half Rate Carriage Position Adjustment
Purpose
To adjust the position of the Full/Half Rate Carriage.
Adjustment
To avoid personal injury or shock, do not perform repair or adjustment with electrical
power applied to the machine.
Check that "Ready to Copy" is displayed on the Control Panel display.
NOTE: Adjust the position of the Front and Rear Full/Half Rate Carriage separately.
1.
Switch off the power and disconnect the power cord.
2.
Remove the Platen Glass. (REP 11.3.1)
3.
Remove the Lens Assembly cover. PL 13.4
4.
Prepare the tools (2) for determining the position. (Figure 1)
1.
Remove the screws (2).
2.
Take out the tools (2).
Reversion 4.0
WorkCentre 7132
WARNING
CAUTION
5.
Align the tool hole in the Half Rate Carriage with the tool hole of the rail (Front/Rear). (Fig-
ure 2)
January 2007
4-261
Figure 1 Taking out the tools
Repairs/Adjustments
ADJ 11.6.1