Rep 13.5.1 Tray 2 Feeder (Ttm) - Xerox WorkCentre 7132 Service Documentation

REP 13.5.1 Tray 2 Feeder (TTM)

Parts List on PL 15.5
Removal
To avoid personal injury or shock, do not perform repair or adjustment with electrical
power applied to the machine.
1. Remove Tray 2 (REP 13.1.1).
2. Open the Left Cover.
3. Remove the Upper/Lower Chute. (Figure 1)
1. Remove the Upper Chute.
2. Remove the Lower Chute.
Figure 1 Removing the Upper/Lower Chute
4. Remove the screw. (Figure 2)
Reversion 4.0
WorkCentre 7132
WARNING
1. Remove the screw.
5. Remove the Tray 2 Feeder Assembly. (Figure 3)
1. Remove the screws.
2. Release the Wire Harness from the clamp.
3. Disconnect the connector.
4. Remove the screws (2).
5. Remove the Tray 2 Assembly.
January 2007
4-117
NOTE: This image is seen as looking in
from the front of the machine and viewing
the rear frame. This screw is one of 3 that
secures the Feeder Assembly.
Figure 2 Removing the screw
Repairs/Adjustments
REP 13.5.1