Xerox WorkCentre 7132 Service Documentation page 720

077-901 Fuser Exit Sensor Jam RAP
BSD-ON:10.2
Paper remains on the Fuser Exit Sensor.
Procedure
Execute Component Control [077-105 Fuser Exit Sensor]. Manually activate the actuator of the
Fuser Exit Sensor (PL 7.1). The display changes.
Y N
Check the connections of P/J125 and P/J410. Connectors are connected correctly.
Y N
Connect P/J125 and P/J410.
Check the wire between J125 and J410 for an open circuit or a short circuit (BSD 10.2
Flag 5/Flag 6). The wire is conducting without an open circuit or a short circuit.
Y N
Repair the open circuit or short circuit.
Measure the voltage between the MCU PWB P410-7 (+) and GND (-) (BSD 10.2 Flag 6).
The voltage is approx. +5VDC.
Y N
Replace the MCU PWB (PL 11.1).
Measure the voltage between the MCU PWB P410-9 (+) and GND (-) (BSD 10.2 Flag 5).
Actuate the Fuser Exit Sensor with paper. The voltage changes.
Y N
Replace the Fuser Exit Sensor (PL 7.1).
Replace the MCU PWB (PL 11.1).
Replace the MCU PWB (PL 11.1).
Revision
WorkCentre 7132
January 2007
2-687
Status-indicator-raps
077-901