4.
Release the hook to remove the actuator.
5.
Remove the Set clamp clutch.
Figure 7 Removing the Set Clamp clutch
9.
Remove the Eject Roll. (Figure 8)
1.
Remove the E-Clip and bearing on both sides.
2.
Remove the hook from the Eject Shaft.
3.
Remove the Eject Roll.
Repairs/Adjustments
REP 16.5.2
Figure 8 Removing the Eject Roll
10. Remove the Eject Shaft. (Figure 9)
1.
Remove the E-Clip and gear.
2.
Remove the E-Clip and bearing on both sides.
3.
Remove the Eject Shaft.
January 2007
4-164
Reversion 4.0
WorkCentre 7132