077-109 IOT Exit Sensor 2 On Jam RAP
BSD-ON:10.3/10.4
After the Fuser Exit Sensor turned On, the Exit 2 Sensor did not turn On within the specified
time.
Initial Actions
Check for torn paper, components out of position, or paper dust in the paper transport path.
Procedure
Check the installation of the Exit 2 Module. The Exit 2 Module is installed correctly.
Y
N
Install the Exit 2 Module correctly.
Check the Transport Roll for wear and paper dust. The Transport Roll is ok.
Y
N
Replace the Transport Roll (PL 15.5).
Open Left Upper Cover Assembly and verify that Exit 1 Gate (PL 8.2) is free to move. Exit 1
Gate is free to move.
Y
N
Repair as required.
Check the clearance between the Diverter Gate and the Fixed Guide on the left hand door. PL
8.3) Operation is satisfactory.
Y
N
Repair as required (PL 8.3)
Execute Component Control [071-102 Exit 2 Sensor]. Actuate the Exit 2 Sensor (PL 8.4) with
paper. The display changes.
Y
N
Check the wire between J112 and J434 for an open circuit or a short circuit (BSD 10.3
Flag 1/Flag 2). The wire between J112 and J434 is conducting without an open cir-
cuit or a short circuit.
Y
N
Repair the open circuit or short circuit.
Replace the Exit 2 Sensor (PL 8.4).
Execute Component Control [047-023 Exit 2 Motor ON]. The Exit 2 Motor (PL 8.4) ener-
gized.
Y
N
Check the wire between J208 and J433 for an open circuit or a short circuit (BSD 10.4
Flag 1). The wire between J208 and J433 is conducting without an open circuit or a
short circuit.
Y
N
Repair the open circuit or short circuit.
Measure the resistance of the Exit 2 Motor (PL 8.4) between J208-1 (COM) and each
point of J208-2/3/4/5 (BSD 10.4 Flag 2). The resistance is approx. 10Ohm.
A
Revision
WorkCentre 7132
A
Y
N
Replace the Exit 2 Motor (PL 8.4).
Replace the Exit 2 Motor (PL 8.4).
Execute Component Control [047-024 Exit Gate Solenoid ON]. The Exit Gate Solenoid (PL
8.4) starts up and the gates start switching.
Y
N
Check the wire between J209 and J433 for an open circuit or a short circuit (BSD 10.4
Flag 3). The wire between J209 and J433 is conducting without an open circuit or a
short circuit.
Y
N
Repair the open circuit or short circuit.
Measure the resistance of the Exit Gate Solenoid (PL 8.4) between J209-1 and J209-2
(BSD 10.4 Flag 4). The resistance is approx. 160Ohm.
Y
N
Replace the Exit 2 Motor (PL 8.4).
Replace the Exit Gate Solenoid (PL 8.4).
Replace the Exit PWB (PL 11.1).
January 2007
2-673
Status-indicator-raps
077-109