Xerox WorkCentre 7132 Service Documentation page 1349

Chain-Link Name
742-307 OHP Sensor PWM Step
742-308 Timing of Starting Paper Type Detection (full speed)
742-309 Timing of Starting Paper Type Detection (half speed)
742-310 Threshold for Judging Paper Type
742-311 OHP Sensor Fail Judgment Value
742-312 Timing of Detecting OHP Sensor Fail
742-314 OHP Sensor Standard Value Adjustment Range
742-319 No Paper Run & Jam Bypass
742-320 Selecting where to output Test Print
742-321 Selecting whether/how to offset-output Test Print
742-322 Component Control Feed /Lift Up Motor Speed
(all the trays)
742-323 Pre Feed SNR ON Jam Timer (all the trays)
742-324 Feed Out SNR ON Jam Timer (all the trays)
Chain 744-xxx FUSER
Chain-Link Name
744-001 Control Temperature in Low Power Mode
744-004 Failure Detection Flag
744-005 Abnormal-Amplified-Difference Detection Flag
744-008 Ready Temperature 1
744-009 Ready Temperature 2
744-010 Standby Temperature
General procedures information
IOT NVM List
Table 3 Paper Handling
Step Read/
Default Range (mm) Write
1 1~30 0.1% RW
95 0~255 1ms RW
95 0~255 2ms RW
620 0~1023 1 RW
125 0~200 0.5% RW
40 0~90 10ms RW
20 1~250 0.1% RW
0 0~15 RW
0 0~4 RW
0 0~2 RW
17 0~17 RW
0 -20~20 10ms RW
0 -30~30 10ms RW
Table 4 Fuser
Read/
Default Range Step Write
140 0~200 1 deg C RW
0 0~3 RW
0 0~1 RW
150 100~200 1 deg C RW
165 100~200 1 deg C RW
175 100~200 1 deg C RW
January 2007
6-26
Description
Adjusts in steps of what amount OHP Sensor PWM Output should be
decreased.
Timing of starting paper type detection after Regi Clutch ON (full speed)
Timing of starting paper type detection after Regi Clutch ON (half speed)
Adjusts threshold used to judge paper to be transparent in paper type detection.
Adjusts, in OHP correction operation, value used to judge from OHP PWM out-
put that OHP Sensor failed.
Adjusts the timing of trying to detect OHP Sensor Fail.
Value used to adjust standard value in OHP correction operation
0: Normal mode
1: Jam Bypass
2: No Paper Run
3: Check IBT
Switch where to output Test Print
0: Face Down Tray #1 / Finisher Stacker
1: Face Down Tray #2
2: Face Up Tray
Offset selection
0: No Offset
1: Front Offset
2: Rear Offset
Applies only when Output Tray is Face Down Tray #2
Specifies the speed of Feed/Lift Up Motor in Component Control.
Jam Timer Value Adjustment
Jam Timer Value Adjustment
Description
Target temperature of NCS-Center in Low Power Mode
0: Normal
1: Abnormal high temp of NCS-Center detected
2: Abnormal high temp of STS-Front detected
3: Abnormal temp of NCS/STS
0: Normal
1: Abnormal amplified difference detected
Reversion 4.0
WorkCentre 7132