Xerox WorkCentre 7132 Service Documentation page 1202

6. Scroll through the Procon "ON" Print items list, find and check that the Items in table 1
are all OK.
PRO CON On Print
Target ADC - H
ADC Measurement - H
ADC LS 1 Measurement - H
ADC LS 2 Measurement - H
Target ADC - M
ADC Measurement - M
ADC LS 1 Measurement - M
ADC LS 2 Measurement - M
Target ADC - L
ADC Measurement - L
ADC LS 1 Measurement - L
ADC LS 2 Measurement - L
ADC Patch Fail
ADC Sensor Fail
ADC Shutter open Fail
ADC Shutter close Fail
ADC Mini setup Fail
Charge Bias Voltage setting Common
Illumination Settings
Maximum Illuminations
Bias Settings
Target TC
TC Measurement
TC Patch Fail
Temperature
Humidity
Temperature Fail
Humidity Fail
Reversion 4.0
WorkCentre 7132
Table 1 PRO CON "On Print"
Yellow Magenta Cyan
385 340 400
368 364 395
455 402 484
352 254 307
680 605 645
656 642 663
710 675 718
635 521 586
915 910 915
923 931 937
041 951 965
831 839 835
OK OK OK
OK - -
OK - -
OK OK OK
715 715 715
396 327 321
673 673 673
575 580 580
433 423 417
400 332 341
OK OK OK
26 - -
52 - -
OK - -
OK - -
January 2007
4-251
7. If any items indicate NG (Fail), check for failed components: Return to Call Flow and
determine component failure, etc. High Voltage Power Supply, ADC Assembly, Developer
Housing, MCU PWB, Photoreceptor, bad Developer Bias.
NOTE: Most values in this table are for reference only. Actual values will vary.
Black (K)
165 Compare the Target ADC - H with the ADC Measurement - H. The
Measurement should be within 30 bits of the Target. (Ignore ADC LS
166
1 Measurement - H and the ADC LS 2 Measurement -H)
213
If not See Corrective Action 1
127
475 Compare the Target ADC - M with the ADC Measurement - M. The
Measurement should be within 30 bits of the Target. (Ignore ADC LS
500
1 Measurement - M and the ADC LS 2 Measurement -M)
543
If not See Corrective Action 1
465
845 Compare the Target ADC - L with the ADC Measurement - L. The
Measurement should be within 30 bits of the Target. (Ignore ADC LS
848
1 Measurement - L and the ADC LS 2 Measurement -L)
866
If not See Corrective Action 1
705
OK If NG see Corrective Action 8
- If NG see Corrective Action 3
- If NG see Corrective Action 2
OK If NG see Corrective Action 9
715 If NG see Corrective Action 10
409
673
565
281 Compare the TC Target with the TC Measurement value. The Mea-
surement should be within 30 bits of the Target.
266
If not see Corrective Action 4
OK If NG see Corrective Action 5
-
-
- If NG see Corrective Action 6
- If NG see Corrective Action 7
Remarks
Repairs/Adjustments
ADJ 9.1.10