Xerox WorkCentre 7132 Service Documentation page 749

093-320 Developer Motor Failure RAP
BSD-ON:4.3A
The Developer Motor is not rotating at the specified speed.
Initial Actions
• Power OFF/ON
• Reload the Xero/Developer Cartridge (PL 4.1)
Procedure
Execute Component Control [042-004 Developer Motor ON]. The Developer Motor can be
heard.
Y N
Go to the OF 5 (Developer Drive ASSY RAP).
Check the installation of the Developer Drive Assembly (PL 1.1). The
Assembly is installed correctly.
Y N
Install the Developer Drive Assembly correctly.
Check the wire between P/J409 and P/J213 for an open circuit or a short circuit (BSD 4.3A).
The wires are conducting without an open circuit or a short circuit.
Y N
Repair the open circuit or short circuit.
Manually rotate the Developer Motor rotor. It rotates smoothly.
Y N
Check for foreign substances that are interfering with operation or installation failure.
Foreign substances or installation failure are found.
Y N
Replace the Developer Drive Assembly (PL 1.1).
Remove the foreign substances that are interfering with operation and correct the installa-
tion failure.
Replace the Developer Drive Assembly (PL 1.1) If the problem persists, replace the MCU PWB
(PL 11.1).
Status-indicator-raps
093-320, 093-400
093-400 Black Toner Near Empty
Black Toner Cartridge is near empty
Procedure
Check the following:
• Replace the Black Toner Cartridge if empty (PL 5.2)
• That the Black Toner Cartridge is inserted properly
• For Black Toner spills in the machine
Developer Drive
January 2007
2-716
Revision
WorkCentre 7132