Rep 12.16 Feed, Nudger, And Retard Roll; Rep 12.17 Paper Height Sensor - Xerox DocuPrint N2025 Service Manual

REP 12.16 Feed, Nudger, and Retard Roll

Parts List on PL 12.3
Removal
Switch off the power and disconnect the Power Cord.
1. Open the 2000 Sheet Feeder tray.
2. Open the Upper Rear Cover.
3. From the rear loosen the two thumb screws and remove the paper baffle.
4. From the rear of the feeder, carefully lift the locking tab on the roll you wish to change (Fig-
ure 1).
5. Slide the roll off the end of the shaft (Figure 1).
Figure 1 Feed, Nudger, and Retard Roll
Replacement
1. Reinstall the components in the reverse order.
Initial Issue
DocuPrint N2025/N2825
WARNING

REP 12.17 Paper Height Sensor

Parts List on PL 12.3
Removal
Switch off the power and disconnect the Power Cord.
1. Remove the 2000 Sheet Feeder Tray Assembly (REP 12.7).
2. Hold the Nudger Assembly down as you release the three locking tabs that secure the
Paper Height Sensor (Figure 1).
3. Disconnect P/J611 from the sensor (Figure 1).
Figure 1 Paper Height Sensor
Replacement
1. Reinstall the components in the reverse order.
02/2000
4-85
WARNING
Repair-Adjustment
REP 12.16, REP 12.17