Xerox WorkCentre 7132 Service Documentation page 1162

10. Remove the ENT Lower Chute Assembly. (Figure 6)
(1)Remove Screws (2).
(2)Loosen Screws (2).
(3)Remove ENT Lower Chute Assembly.
Figure 6 Removing the ENT Lower Chute Assembly (j0fa42237)
Replacement
1. Reverse the removal procedure for replacement.
Reversion 4.0
WorkCentre 7132
REP 22.6.1 ENT Roll Assembly
Parts List on PL 22.6
Removal
To avoid personal injury or shock, do not perform repair or adjustment with electrical
power applied to the machine.
Before turning OFF the power switch, note the following to prevent loss of customer data.
[with the FAX function]
Check that the "Job in Memory" lamp is off. Press the "Job Status" button and check that no job
is in progress.
[with the Printer function]
Check that "Ready to print/send" is displayed on the Control Panel.
1. Remove the A-Finisher from the machine.
2. Remove the Inner Front Cover. (PL 22.1)
3. Remove the Rear Cover. (PL 22.1)
4. Remove the Left Cover. (PL 22.2)
5. Remove the Upper Frame Section. (Figure 1)
(1)Remove Screw and Bracket.
(2)Remove Screws (2).
(3)Remove Screw and Bracket.
(4)Remove Screws (2).
(5)Remove the Upper Frame Section
January 2007
4-211
WARNING
CAUTION
Repairs/Adjustments
REP 22.5.5, REP 22.6.1