Xerox WorkCentre 7132 Service Documentation page 1148

REP 22.3.2 Sub Paddle Solenoid
Parts List on PL 22.3
Removal
To avoid personal injury or shock, do not perform repair or adjustment with electrical
power applied to the machine.
Before turning OFF the power switch, note the following to prevent loss of customer data.
[with the FAX function]
Check that the "Job in Memory" lamp is off. Press the "Job Status" button and check that no job
is in progress.
[with the Printer function]
Check that "Ready to print/send" is displayed on the Control Panel.
1. Remove the A-Finisher from the machine.
2. Remove the Inner Front Cover. (PL 22.1)
3. Turn over the A-Finisher.
4. Remove the Bottom Cover. (PL 22.2)
5. Disconnect the Connector. (Figure 1)
(1)Release Clamps (3) and remove the wire.
(2)Disconnect Connector.
Figure 1 Disconnecting the Connector (j0fa42210)
6. Turn over the A-Finisher.
7. Remove the Sub Paddle Solenoid Assembly. (Figure 2)
Reversion 4.0
WorkCentre 7132
WARNING
CAUTION
(1)Disconnect Connector.
(2)Release Wire from Hook.
(3)Remove Screws (2).
(4)Remove Sub Paddle Solenoid Assembly.
Figure 2 Removing the Sub Paddle Solenoid Assembly (j0fa42211)
8. Remove the Support. (Figure 3)
(1)Remove Screw.
(2)Remove Support.
Figure 3 Removing the Support (j0fa42212)
January 2007
4-197
Repairs/Adjustments
REP 22.3.2