077-907 Duplex Wait Sensor RAP
BSD-ON:10.6
Paper remains on the Duplex Sensor.
Procedure
Execute Component Control [077-104 Duplex Sensor]. Actuate the Duplex Sensor (PL 10.1)
with paper. The display changes to L.
Y
N
Check the wire between J123 and J541 for an open circuit or a short circuit (BSD 10.6
Flag 1/Flag 2). The wire between J123 and J541 is conducting without an open cir-
cuit or a short circuit.
Y
N
Repair the open circuit or short circuit.
Replace the Duplex Sensor (PL 10.1) If the problem persists, replace the Duplex PWB
(PL 10.1).
Replace the Duplex PWB (PL 10.1).
Status-indicator-raps
077-907 , 077-967
077-967 Paper Kind Mismatch RAP
The specified paper type and the paper type being used are different.
Initial Actions
Perform the following:
•
Switch the power off then on.
•
Check if the Regi Sensor actuator is operating properly.
•
Check the paper type.
•
Check the paper type settings.
Procedure
Load the paper type selected. If problem still exists, replace the MCU PWB (PL 11.1).
January 2007
2-690
Revision
WorkCentre 7132