Xerox WorkCentre 7132 Service Documentation page 1532

GP 10 Loading And Upgrading Software
Description
This procedure enables updating the machine software (ESS, FAX, IISS, IOT) or when rein-
stallation of the software is required due to a failure. The WC 7132 PWS Diagnostic tool for
software download comes with the system software disc.
This procedure is generic in nature and is intended as an overview only. Always follow the
instructions that come with the software. There may be additional steps added, or other special
requirements that vary from version to version.
Procedure
1. Using the instructions on the pull out sheet that comes with the system software disc, load
the WC 7132 software download tool on you PWS.
2. Make a copy of the color test pattern 82E13120 and check for Image Quality problems.
Resolve any problems before performing the software loading.
3. Print a copy of the Systems Settings List.
4. Switch off the WC 7132.
5. Disconnect the RJ45 Network Connector to the customer's network.
6. Connect the PWS to the USB 1.1 port on the WC 7132.
Reversion 4.0
WorkCentre 7132
CAUTION
7. Switch on the WC 7132.
8. The Found New Hardware wizard will appear. It will ask to install the Fuji Xerox PWS
USB Interface Driver for 2nd Generation. Select Install the Software Automatically
and select Next. Follow the prompts to complete the driver installation.
9. Go to Product Tools and start the WC 7132 PWS Diagnostic Tool.
NOTE: The actual instructions that accompany the software may have additional steps
here, such as a list of NVM values that need to be recorded.
10. When the tool is connected, select Enter Diagnostics.
January 2007
6-209
Figure 1 WC 7132 Connections
General procedures information
USB 1.1 Device
Port - For connect-
ing the PWS
downloader
(shipped covered)
RJ45 Network
Connector - For
connecting the cus-
tomers network
GP 10