Figure 3 Removing the Developer Bias Brush
Repairs/Adjustments
REP 4.1.3, REP 4.1.4
REP 4.1.4 Waste Toner Auger
Parts List on PL 6.1
Removal
To avoid personal injury or shock, do not perform repair or adjustment with electrical
power applied to the machine.
1.
Switch off the power and disconnect the power cord.
2.
Remove the Waste Auger drive shaft bushing. (Figure 1)
Developer Bias
Brush
NOTE: In the next step, place a sheet of paper under the opening in the Waste Auger when
removing it from the frame.
3.
Remove the Waste Auger. (Figure 2)
January 2007
4-28
WARNING
Figure 1 Removing the Waste Auger drive shaft bushing
2
Remove the Waste Auger
drive shaft bushing
Reversion 4.0
WorkCentre 7132