Xerox WorkCentre 7132 Service Documentation page 1182

Replacement
1. Reverse the removal procedure for replacement.
2. Install and align the Eject Belt with marks on the Pulleys. (Figure 7)
Figure 4 Installing the Eject Belt (j0fa42278)
Reversion 4.0
WorkCentre 7132
REP 22.10.1 Front /Rear Tamper Motor Assembly
Parts List on PL 22.10
Removal
To avoid personal injury or shock, do not perform repair or adjustment with electrical
power applied to the machine.
Before turning OFF the power switch, note the following to prevent loss of customer data.
[with the FAX function]
Check that the "Job in Memory" lamp is off. Press the "Job Status" button and check that no job
is in progress.
[with the Printer function]
Check that "Ready to print/send" is displayed on the Control Panel.
1. Remove the A-Finisher from the machine.
2. Remove the Compile Assembly. (REP 22.9.1)
3. Remove the Bracket Assembly. (Figure 1)
(1)Release Clamps (2) and remove the wire.
(2)Remove Screws (2).
(3)Remove Bracket Assembly.
Figure 1 Removing the Bracket Assembly (j0fa42272)
January 2007
4-231
WARNING
CAUTION
Repairs/Adjustments
REP 22.9.6, REP 22.10.1