Xerox WorkCentre 7132 Service Documentation page 1512

Chain-Link Name
094-007 IBT CLN Retract
094-008 IBT CLN Auger Clutch
094-009 2nd BTR Retract Clutch
094-010 IBT CLN Retract Clutch
Chain-Link Name
005-102 Document Sensor
005-110 Regi Sensor (Belt DADF/CVT)
005-205 DADF Feed Out Sensor
005-206 DADF Pre-Reg.Sensor
005-211 DADF Invert Sensor
005-212 DADF Feeder Cover Interlock Switch
005-213 DADF Platen Interlock Switch
005-215 DADF #1 Tray APS Sensor
005-216 DADF #2 Tray APS Sensor
005-217 DADF #3 Tray APS Sensor
005-218 DADF #1 APS Sensor
005-219 DADF #2 APS Sensor
005-220 DADF #3 APS Sensor
005-221 DADF Tray Size SNR No.1
005-222 DADF Tray Size SNR No.2
005-224 Scan Start
005-225 Nudger Position Snr
062-201 Sheet Abort
Reversion 4.0
WorkCentre 7132
Table 2 Output Component Control Codes IOT
Connector
Level Meaning
- IBT cleaner contact motion.
IBT cleaner retract motion stops
when IBT Cleaner Retract Sensor
detects that IBT cleaner is in contact
position.
1) [I/O]IBT CLN Retract Clutch is
turned on.
2) [I/O]IBT CLN Retract Clutch is
turned off within a period of time
specified by the timer
(nxfr_ClnCntStpTime) after IBT
Cleaner Retract Sensor is turned on.
[Component] Auger Mot needs to be
activated in advance.
- BT CLN Auger Clutch is turned on/
off.
- 2nd BTR Retract Clutch is turned on/
off.
[I/O]2nd BTR Retract Clutch
- BTR CLN Retract Clutch is turned
on/off.
[I/O]BTR CLN Retract Clutch
Table 3 Input Component Control Codes IIT
Connector Level Meaning
H No paper detected by Document Sensor
L Paper detected by Regi Sensor
H Paper detected by Feed Out Sensor
H Paper detected by Pre-Reg. Sensor
H Paper detected by Inverter Sensor
- Feeder Cover open
H Platen Interlock open
L Light is not blocked by the actuator
L Light is not blocked by the actuator
L Light is not blocked by the actuator
L paper detected by APS No.1 Sensor
L paper detected by APS No.1 Sensor
L paper detected by APS No.1 Sensor
L paper detected by Tray Size SNR No.1
L paper detected by Tray Size SNR No.2
H Scan Start Signal ON
H The Nudger Roll is at UP position.
L Document Regist
January 2007
6-189
Timer Off Cycle Operation Remarks
O O The BCR AC, BCR DC, DEVE DC and BTR
output simultaneously. * CF=53-45(CL=751-
560) to 1 (single output) enables indepen-
dent outputs.
O O
O O
Remarks
General procedures information
Component Control