Xerox WorkCentre 7132 Service Documentation page 1019

1
Remove the screws (2)
2
Loosen the screws (2)
Figure 2 Removing the Power Supply PWB
Repairs/Adjustments
REP 9.2.3, REP 9.2.4
REP 9.2.4 Print Chassis Assembly
Parts List on PL 11.2
Removal
1. Disconnect the Ethernet cable.
2. Switch off the power and disconnect the power cord.
3. Remove the ESS Cover. (REP 10.2.1)
4. Remove the Printer Chassis Assembly by loosening the thumb screws (3). (PL 11.2)
Replacement
3
1. Install the Printer Chassis Assembly in reverse order of removal.
Lift up the Power
Supply Chassis and
2. Connect the power cord and switch on the power.
remove from the
3. Verify that the machine has the correct level of ESS Controller software. If necessary,
machine
upgrade the software to the correct version.
May 2006
4-68
Launch Version 3.0
WorkCentre 7132