Xerox WorkCentre 7132 Service Documentation page 1153

REP 22.4.4 Exit Roll Assembly
Parts List on PL 22.4
Removal
To avoid personal injury or shock, do not perform repair or adjustment with electrical
power applied to the machine.
Before turning OFF the power switch, note the following to prevent loss of customer data.
[with the FAX function]
Check that the "Job in Memory" lamp is off. Press the "Job Status" button and check that no job
is in progress.
[with the Printer function]
Check that "Ready to print/send" is displayed on the Control Panel.
1. Remove the A-Finisher from the machine.
2. Remove the Inner Front Cover. (PL 22.1)
3. Remove the Rear Cover. (PL 22.1)
4. Remove the Left Cover. (PL 22.2)
5. Remove the Upper Frame Section. (Figure 1)
(1)Remove Screw and Bracket.
(2)Remove Screws (2).
(3)Remove Screw and Bracket.
(4)Remove Screws (2).
(5)Remove the Upper Frame Section
Repairs/Adjustments
REP 22.4.4
WARNING
CAUTION
Figure 1 Removing the Upper Frame Section (af422101)
NOTE: The screws do not thread into the Upper Chute. They are used like pins to secure
the Upper Chute in place.
6. Remove the Upper Chute Assembly. (Figure 2)
(1)Remove Screws (2).
(2)Remove Screw.
(3)Carefully Remove the Upper Chute Assembly.
January 2007
4-202
Reversion 4.0
WorkCentre 7132