Figure 3 Preparing to remove the Developer Housing
4.
Move the Developer Housing toward the front then remove the Developer Housing. (Fig-
ure 4)
Repairs/Adjustments
REP 4.1.1
3
Remove the screw
(1)
2
Manually rotate the Rotary until the
Developer Housing to be removed is
in position and release the Rotary
Release Knob
1
Push in and hold
the Rotary Release
Knob
January 2007
4-24
1
Move the Developer
Housing to the front
Figure 4 Removing the Developer Housing
Replacement
1.
When reinstalling the Developer Housing, ensure that the Spring, located on the outboard
end of each Developer Housing, is straight as it is pressed against the turret of the Rotor
frame. This Spring must be present, and properly installed. (Figure 5)
2
Then remove the Devel-
oper Housing
Reversion 4.0
WorkCentre 7132