Iq16 Spots Rap - Xerox WorkCentre 7132 Service Documentation

IQ16 Spots RAP

Initial Actions
Ensure that the paper in use is fresh, dry, and within specification for weight and quality.
Check print driver and copier control panel settings to ensure the media is being run in the
proper mode.
Compare the spots against the samples in the Image Quality Defects supplement. If the defect
matches the Debris Centered Deletions sample, go to the IQ7 RAP.
Procedure
The defect occurs in Copy mode only.
Y N
The spots occur at a fixed interval on each print.
Y N
NOTE: The repetition rate for Transfer Belt defects varies considerably, depending
on paper size and mode of operation. The defect may appear on every sheet, or may
occur on every other sheet.
The defect occurs in approximately the same position on multiple prints.
Y N
The problem is Fuser offset and/or lead edge smears or spots.
Y N
Do not use a vacuum cleaner or any solvents in the following step. Dam-
age to the Belt Cleaner will result.
Remove the IBT Cleaner (REP 4.2.4). Carefully clean the cleaning blade
and the Mylar shield with a soft brush or a lint free cloth. Brush away any
accumulation of toner on the foam seal and the outside surfaces. Wipe the
surface of the Transfer Belt with a lint free cloth.
If the problem continues, replace the IBT Cleaner (PL 6.1).
Go to the IQ13 RAP.
Check the IBT Belt (PL 6.1) for dirt or damage. Clean or replace as required.
Go to the IQ14 RAP.
Ensure that the original is free from the defect.
Clean the Platen Glass and Lens.
Reversion 4.0
WorkCentre 7132
CAUTION
January 2007
3-15
Image Quality
IQ16